F6 xp install sata driver usb

Press the Esc key to exit the BIOS Setup Utility and reboot the workstation using the Windows XP installation media. When Press F6 if you need to install a third-party SCSI or RAID driver appears at the bottom of the Windows Setup screen, press F6 and follow the instructions to install the RAID driver from the USB floppy drive. Press S to specify an additional device. A .  · Installing Windows XP With F6 AHCI/RAID Drivers From USB Only. Sometimes installing Windows can be a truly challenging problem. For example, if you need to install Windows XP (because it's an old hardware uncapable of running something better), and you need to install operating system to the SATA HDD in AHCI mode or to the RAID controller (with. Windows XP does not provide drivers for all the SATA controllers, therefore, during the installation procedure, the user must insert a floppy with the drivers that came in Estimated Reading Time: 5 mins.

Press the Esc key to exit the BIOS Setup Utility and reboot the workstation using the Windows XP installation media. When Press F6 if you need to install a third-party SCSI or RAID driver appears at the bottom of the Windows Setup screen, press F6 and follow the instructions to install the RAID driver from the USB floppy drive. Press S to specify an additional device. A list appears. Select the Intel ICH10R RAID SATA controller from the list and proceed with the installation. When Windows prompts you (shown at the bottom of screen), press the F6 key to install the third party drivers for the Serial ATA hard drive. You do not have a floppy drive. In this case, you need to unzip the drivers for the SATA controller and use the nLite software to integrate them on the Windows XP installation CD. Acer Extensa same problem with SATA. Dowloaded the drivers SATA from Acer. Copied to USB, files in/out original folder. Inserted while I was installing the XP. Did the F6 gig,didn't worked. Restarted the whole process with usb inserted and . MIRACLE!!! My HDD was there. Good luck:).

Installing Windows using native SATA drivers · Boot the notebook PC. · Insert the Windows XP installation CD into the optical CD/DVD drive. · Press the F6 key when. If I do press f6, I am prompted to submit drivers from a FLOPPY DRIVE ONLY. The Hitachi support site says "you don't need this driver etc . Next: · Windows XP in - 20 Years Later · Install Windows XP from an ISO on a USB drive onto a SATA hard disk without nLite (using Easy2Boot).